Back to my Manx...

I decided yesterday, it's time to finish a project I have started in recent months.  I'd like nothing more than to share a finished project with you today, but I'm still not quite there yet.

One of the things that has stalled me from finishing my second (or is it my third?) Manx project was that when I sewed the squares together (a few weeks ago now), I realized (afterwards) that I should have trimmed them all down first.  They finished differently sized, and while I got the fronts of the squares sewed together, they didn't match up all that well, and the extra fabric on the backs was just too much to deal with.

So, I took them apart, and went back to the cutting board.

With squares that now approximated each other in size, I set myself again to the task of sewing the fronts together.  My pictures don't do justice to how complicated it was to put these together properly.  I honestly don't know how people made these before modern sewing equipment, and things we take for granted like fine straight pins and electric irons.

I was thankful I had recently purchased some heat resistant straight pins, so I could pin and press to my heart's content, in order to manage the many layers.

If you find the multiple layers confusing, believe me...  you are not alone.  Once I committed to sewing each seam, I just hoped I didn't catch any extraneous fabric in the stitches.  

With the fronts of the squares all sewn together, the backs were a bit of a mess.

After much contemplation (i.e. turning this thing in multiple directions, folding, refolding, head scratching and finally pressing and pinning again), I figured out how to finish off the back. 

The back had to be hand-stitched, but I had to decide which long seam should be stitched first.  Once I committed to a plan, pins held all the back pieces together as I wrangled it all, trying not to be pierced by these very sharp thin pins.

Finally...  that part was done.  It's not perfect, but I'm satisfied.   I will note that when trimming these down, I should have left the backs slightly larger than the fronts - like even an extra 1/4 inch - just to provide more fabric to fold over for seam sewing.  As is, this will suffice as a decorative piece, but I don't think my hand-sewn seams on the back are substantial enough to hold up to the kind of use a full-sized quilt would see.

I cannot believe I contemplated for even a few minutes that I might like to make a full-sized quilt of these squares.  My hat is off to anyone who has done so.  I marvel at the finger dexterity and fortitude that would take.  And really... it is beyond my comprehension that people in the 1800's would have made these elaborate-looking squares from scraps of fabric, all completely sewn by hand, likely without the aid of a decent iron for pressing in the folds.  Even if a person had an iron, I doubt they employed one in making this.  It was a bit tedious for me to press each strip before and after sewing - I can't picture someone doing that with an iron that needed retrieving from the fire or stove.  I'm pretty sure they simply finger-pressed as they went.  Which makes this construction even more impressive.

This is the last time I intend to share this project before it's finished.  Here's a tease of the front: